Driver Support Document

Alcatel-Lucent Stinger FS+, OS Version 9.x, 10.x, 11.x

Show Tested Devices Grid

SYSOID Mapping
SYSOID MODEL OS VERSION
 1.3.6.1.4.1.529.1.7.6 Stinger FS+ 9.12.0e2, 10.x, 11.x

Driver Features Support Grid

Driver FeaturesAccess Methods
(X signifies feature support)CLISNMPTFTPCLI+TFTPSNMP+TFTPFTPCLI+FTPSNMP+FTPCLI+SFTPSCPCLI+SCPSNMP+SCPHTTP/HTTPS
X Driver Discovery release notes X X                      
X General Access  
(CLI protocols: telnet, ssh1, ssh2, console)
Supports SecurID 		X     X                  
Configuration
X Retrieve Running Configuration   X     X                  
  Retrieve Startup Configuration                            
  Retrieve Binary Configuration                            
X Device information parsing  
X Enhanced Layer2 Basic IP information parsing  
X Configuration Deployment to Running         X                  
  Configuration Deployment to Startup                            
  Binary Configuration Deployment                            
Diagnostics
X Routing Table   X                        
X OSPF Neighbors   X                        
X Interfaces   X                        
X Modules and Inventory   X                        
  Flash Storage Space                            
X File System   X                        
X Uptime     X                      
X ICMP Test   X                        
X Topology Parsing   X                        
  Duplex Parsing                            
  Enhanced VLAN Parsing  
Features
  Software Center                            
  Software Image Synchronization                            
X Password Management release notes
(Can modify: full username, full password, read-only community strings, read/write community strings) 		X                        
X Syslog Configuration and Change Detection   Syslog patterns X                        
X Custom Scripts and Diagnostics  
Bulk deploy available 		X                        
X ACL Parsing  
X ACL Provisioning   X                        
  VLAN Provisioning                            
  Configlet Parsing  
  QoS Parsing  
  VRF Parsing  
  Context Management                            

Password Management

Release Notes

User name change

When the active user name is changed a new profile is created. The old user name profile cannot be deleted because it would terminate the connection to the device.

return to top

Driver Discovery

Release Notes

CLI Discovery

CLI Discovery fails if telnet password is set. To disable telnet password use the following commands: 1. read ip-global 2. set telnet-password = "" 3. write

More prompt causes an unexpected disconnection

Discovery tasks for Javascript drivers handle More prompts by using timeouts, which can cause problems with the third-party SSH client code, which interprets the timeout as a disconnection. There are two options to work around the problem. Setting the RCX option [<option name="Driver/Discovery/UsePollRead">true</option>] in site_options.rcx will effect the workaround for all affected devices. Alternatively, it could be applied to a single device by setting the device access variable "PollRead" to "true".

Wakeup Ctrl-U character can cause discovery to fail

Discovery tasks for Javascript drivers use wakeup characters are sent during device connection, to ensure that the device is responding. Normally, these characters do not echo to the console, but some devices may echo them. In this case, this causes the prompt detection phase to fail, which in turn can cause More prompts to not be handled properly, and discovery may fail. If these characters are echoed from the device [check the session log to see this], then set the device access variable "skip_ctrl_u" to skip the sending of the wakeup characters. Note that setting this option on a previously working device could cause discovery tasks to fail, but it only affects CLI discovery. SNMP discovery is unaffected.

return to top

Syslog Triggering

return to top