Setting up the Multi-Tenancy Integration in UCMDB

You need to perform the following tasks in UCMDB to set up the multi-tenancy integration.

  1. Install a separate data flow probe for each tenant the integration will support.

    See How to Install a Separate Data Flow Probe for Each Tenant.

  2. Start tenant-specific data flow probes.

    See How to Start Tenant-Specific Data Flow Probes.

  3. Configure IP address ranges for tenant-specific data flow probes.

    See How to Configure IP Ranges for Tenant-Specific Data Flow Probes.

Caution Multi-tenancy is not supported for population when the integration uses the Service Manager Enhanced Generic Adapter.