Use > Data Flow Management > Universal Discovery > Inventory Discovery > How to Configure XML Enricher to Suit the Probe Deployment Mode

How to Configure XML Enricher to Suit the Probe Deployment Mode

When the Data Flow Probe is installed, the XML Enricher is configured, by default, for the Standard Deployment mode.

Note The XML Enricher’s Windows service is configured with the Manual start up and the probe starts the XML Enricher service on demand when necessary. So you should not change the startup mode of the XML Enricher service.

If another Probe deployment is used, the XML Enricher settings must be manually adjusted to fit the deployment mode of the Probe.

Note  

  • The XML Enricher configurations described below have been tested against the Data Flow Probe deployment modes.

    However, other configurations may potentially be supported, provided that enough resources (memory and CPU) are available for the XML Enricher.

    For details about the Data Flow Probe deployment modes, see the Universal CMDB Support Matrix document.

  • This task relevant for Data Flow Probes meant for discovery (on Windows machines) only.

Related Topics Link IconRelated Information