View Route List P.01 Grade of Service Summary Report

This report helps you to do call routing capacity planning by generating the usage summary of all Cisco Route Groups referenced by specific selected Route Lists configured on Call Manager clusters.

This report is applicable only for the Route Lists that has at least one Route Group referencing channelized Cisco Voice Gateways or channelized Cisco Voice Gateway interfaces such as T1/E1 PRIs. This report captures a summary of the usage for each Route Group referenced by each Route List. The report displays the summary for each Route Group referenced by the Route Lists where the summary for each Route Group represents the summary similar to what you can generate for that Route Group from the Cisco Route Group P.01 GoS Summary tool. For more information on Cisco Route Group P.01 GoS Summary, see View Route Group P.01 Grade of Service Summary Report

• You must configure Cisco AXL Data access configuration as specified in the "Configuring Data Access for Cisco" section before viewing this report.
• You must configure Cisco CDR access configuration as specified in the "Configuring Data Access for Cisco" section before viewing this report.
• You must enable CDR-based reporting as specified in the "Configure Cisco IP Telephony CDR-based Reporting" section before viewing this report.

To access the Route List P.01 GoS Summary Report:

1. Log on to the NNMi console as an operator.

2. Click Cisco IP Telephony > UCM Clusters.

3. Select a Cisco Unified Communications Manager cluster of your choice, and then click Actions > IP Telephony > Route List P.01 GoS Summary. The Grade of Service for Route List window opens.
4. Specify the following details on the left panel:
   • Fraction*: Specify the numeric value that denotes the percentage of busiest day calls to be taken as the estimated busy hour calls offered. The default value is 14 for this parameter.
   • Start Date: Specify the start date for the report.
   • End Date: Specify the end date for the report.
   recommends that you provide a gap of a day or more between the start date and the end date to generate reports. By default, the NNM iSPI for IP Telephony generates the report for the past one week.
   • Direction: Select one of the following options to specify the type pf calls that must be considered when generating reports.
     • In: indicates incoming calls.
     • Out: indicates outgoing calls.
     • Both: indicates both incoming and outgoing calls.
   • Time Zone: Select the time zone configured in your system. You must select the Default time zone if NNMi and the iSPI Performance for Metrics are installed on different time zones.
   • Cluster ID: Specifies the cluster identifier.
   • Route List: select the route lists based on which you want to monitor the usage of the route groups and calculate the P.01 GoS score.
5. Click Submit. This generates the report.

The Route Lists reference the gateway devices through references to the Route Groups. The Route Groups reference the Gateway devices. In order to see the detailed summary for each gateway in a given Route Group, you can filter the detailed Gateway Summary table by entering the name of the Route Group noted from the Route Groups Summary table for any Route List.

The Selection Order in the report indicates the priority or position of the Route Group within a given Route List.

The GOS Reference Chart lists the number of channels and the recommended GoS score for the number of channels.